It perfectly solves two major pain points: the traditional power frequency (50Hz) test equipment is bulky and heavy, making it impossible to move on-site, and DC withstand voltage testing is prone to generating "space charge" in XLPE cables, leading to insulation damage.
Combined with the technical standards and application status in 2026, here is an in-depth analysis of this device:
1. Core Principle and Necessity
Why is Very Low Frequency (0.1Hz) needed?
Capacitive current is significantly reduced: A cable is equivalent to a large capacitor. According to the formula
When f is reduced from 50Hz to 0.1Hz, the required test current is only 1/500 of the power frequency. This means that the power supply capacity and transformer size can be reduced by hundreds of times, allowing the equipment to fit into a van or even a suitcase, making it easy to conduct on-site tests in tunnels and cable trenches.
When f is reduced from 50Hz to 0.1Hz, the required test current is only 1/500 of the power frequency. This means that the power supply capacity and transformer size can be reduced by hundreds of times, allowing the equipment to fit into a van or even a suitcase, making it easy to conduct on-site tests in tunnels and cable trenches.
Avoiding DC damage: In the past, DC withstand voltage testing was commonly used for XLPE cables, but the DC electric field can accumulate space charge within the insulation layer, forming local high field strength after voltage removal, which accelerates cable aging and even causes breakdown after commissioning. The 0.1Hz AC voltage combines the distribution characteristics of an AC electric field (no space charge generation) with the portability of very low frequency, making it the internationally recognized (IEEE 400.2, IEC 60502) preferred method for XLPE cable commissioning and preventive testing.
Waveform standards:
Cosine Rectangular: Early mainstream, mature technology, but slightly higher harmonic content.
Sine Wave: The mainstream trend in 2026. The waveform is purer, closer to actual operating conditions, and more accurate for insulation assessment, meeting the latest national standards.
2. Key Technical Parameters (2026 Edition)
When selecting, the following indicators need special attention:
Output frequency: Standard is 0.1Hz, high-end models support 0.01Hz - 0.5Hz continuously adjustable (for testing cables of different lengths or generators).
Output voltage: Common levels are 30kV, 40kV, 50kV, 60kV, 80kV.
The test voltage for 10kV cables is usually
Induced Withstand Voltage Test Device
Qwen3.5-Plus
